On/Off Switch; Function Button - Domo DO7347H Manual De Instrucciones

USE
Before you use the appliance: plug in the appliance and turn on the on/off switch at the back of the device.
The display displays the symbol
mode. You can set the appliance using the control panel, but also using the remote control. You can make
the settings in the same way. The display will show you the selected settings. Each time a button is
pressed, the device emits an audible signal to indicate that the user is making a setting or adjustment.

ON/OFF SWITCH

Push the on/off switch to turn on or off the appliance. "HI" and the
the device is switched on. This means the device is at its highest power setting. If you switch off the
device, the display will count down from 15 to 0 in order to cool itself down.
Note: when the device is switched off via this button, the device goes into standby mode. This means it is
not completely disabled. You can only switch the device off completely via the on/off switch on the back
of the device.

FUNCTION BUTTON

1. Press the button once: low power (1200 W): "LO" appears on the display, the device is now operating
at its lowest power setting.
2. Press the button a second time: ECO: the
temperature between 5-35 °C as desired using the buttons to increase
can also keep this button pressed until you reach the desired setting. If the ambient temperature is 2
°C higher than the set temperature, the device switches to standby mode. If the temperature falls
back below the set temperature, the eco function switches on again. This is the most energy-
efficient way to maintain the temperature.
Note: the device remembers the last temperature setting made. This means that when you switch
the device on again, the last temperature setting appears on the display when eco mode has been
selected.
3. Press the button for a third time: high power (2000 W): "HI" appears on the display, the device is
now operating at its highest power setting.
TIMER
1. Push this button to set the timer. The
2. You can set this between 1-8 hours using the buttons to increase
also press and hold this button until you reach the desired setting.
3. When the selected time has been expired, the appliance will enter the stand-by mode and will no
longer emit heat.
Note: if the device is in stand-by mode, you can set the timer. After the set time has elapsed, the device
switches itself on automatically and will operate at its highest power setting.
OSCILLATION
Press the oscillation button to allow the heater to oscillate the air from left to right and vice versa. Press
this button again to stop this. If you switch the device off with the on/off button, this function stops even
if you have not pressed the oscillation button.
www.domo-elektro.be
and emits an audible signal to indicate that the device is in standby
symbol appears on the display. You can set the
symbol appears on the display.
symbol appear on the display when
and to decrease
and to decrease
. You
. You can
27
DO7347H