Hotpoint Ariston FQZI 89 P (K)/HA Manual De Instrucciones página 26

Automatic cleaning with the FAST CLEAN function
GB
With the FAST CLEAN mode, the internal temperature of the oven reaches
500°C. The pyrolytic cycle is activated, burning away food and grime residues.
Dirt is literally incinerated.
Keep children away from the appliance during the automatic cleaning cycle
as surfaces may become very hot. Particles may ignite inside the oven due
to the combustion process. There is no cause for concern: this process is
both normal and hazard-free.
Before initiating the FAST CLEAN mode:
• clean the oven door;
• remove large or coarse food residues from the inside of the oven using a
damp sponge. Do not use detergents;
• remove all accessories and the sliding rack kit (where present);
• Do not place tea towels or pot holders over the oven handle.
• Turn the SELECTOR knob to the "0" position.
! If the oven is too hot, the pyrolytic cycle may not start. Wait for the oven
to cool down.
! The programme may only be started once the oven door has been closed.
To activate the FAST CLEAN cycle press and hold the
approximately 4 seconds. The TIMER KNOB may be used to select the
desired cleaning level; there are three default time settings which cannot
be modified.
1. Economy (ECO): turn the knob towards " ". Duration 1 hour.
2. Normal (NOR): initial level. Duration 1 hour and 30 minutes.
3. Intensive (INT): turn the knob towards " ". Duration 2 hours.
4. Press the button to confirm.
An end time for the FAST CLEAN cycle (as for a normal cooking cycle)
may be programmed (see Programming the automatic cleaning end time).
Safety devices
• The icon on the display, when lit, indicates that the oven door was
automatically locked as soon as the temperature reached a high value.
• The icon indicates that the cleaning cycle may be cancelled
at any time by pressing the
• If a malfunction occurs, the heating elements will be switched off.
• Once the oven door has been locked, you cannot change the duration
and cycle end time settings.
Programming the automatic cleaning end time
1. Press the button until the
DISPLAY begin to flash.
2. Turn the TIMER KNOB towards " " and " " to adjust the hour value.
3. Press the button again until the other two digits on the DISPLAY
begin to flash.
4. Turn the TIMER KNOB towards " " and " " to adjust the minute value.
5. Press the button again to confirm.
6. When the set time has elapsed, the text END appears on the display
and a buzzer sounds.
• For example: it is 9:00 a.m. and the Economy (ECO) FAST CLEAN level
has been selected, with the default duration of 1 hour. 12:30 is scheduled
as the end time. The programme will start automatically at 11:30 a.m.
Programming has been set when the
illuminated. The display shows the FAST CLEAN end time and duration
alternately.
26
button for
button.
icon and the two digits on the
and buttons are
Once the automatic cleaning cycle is over
You will have to wait until the temperature inside the oven has cooled down
sufficiently before you can open the oven door. You will notice some white
dust deposits on the bottom and the sides of your oven; remove these
deposits with a damp sponge once the oven has cooled down completely.
Alternatively, you can make use of the already heated oven, in which case
it is not necessary to remove the deposits, they are completely harmless
and will not affect your food in any way.