Contact; About These Operating Instructions - Multiplex SMART SX FLEXX Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Introduction
1.2
1.3
SMART SX FLEXX
The transmitter software (= firmware) can be updated via an integrated
interface in the battery compartment, which enables you to keep up with the
latest technical standards at all times.

Contact

We have made every effort to design these operating instructions in such a way
that you can find an answer to each question quickly and easily. Should you still
have any questions regarding your radio control, please feel free to contact your
specialist dealer who will be happy to assist you.
Service partners
The addresses of our service partners are available on our website:
http://www.multiplex-rc.de
under
SERVICE / SERVICE ADDRESSES

About these operating instructions

These operating instructions describe the SMART SX FLEXX radio control and
contain the following chapters:
Chapter 1 "Introduction" provides an overview of the
SMART SX FLEXX concept.
Chapter 2 "Safety instructions" contains important information concerning
safety, intended use and warranty.
Chapter 3 "Transmitter" describes:
The SMART SX FLEXX transmitter with its controls.
o
How to setup the transmitter for operation.
o
How to perform a range check and the binding procedure.
o
How to perform a firmware update.
o
Chapter 4 "Receiver" describes the controls of the RX-5 light M-LINK ID1
receiver as well as the Fail-Safe and Reset functions.
Chapter 5 "Tamiya model trucks" describes the connections in the model as
well as the assignment of the functions to the operation of Tamiya model
trucks.
Page 47

Publicidad

Tabla de contenido
loading

Tabla de contenido