Receiver; Controls; Fail-Safe - Multiplex SMART SX FLEXX Manual De Instrucciones

4
4.1
4.2
Page 62

Receiver

The RX-5 M-LINK receiver with Smart ID is included in the scope of delivery of the
set.

Controls

Fig. 3: RX-5 light M-LINK ID 1 receiver
1 Status LED

Rapidly flashing yellow light: binding mode

Slowly flashing yellow light: normal mode
2 SET button
3 Servo sockets, channel 1 to 5

Fail-Safe

The receiver is equipped with a Fail-Safe function. If the transmitter fails, the
servos assume the pre-programmed positions.
This significantly increases reliability when using a model. Move the actuators on
the transmitters to a position where the servos assume the desired position. Once
this is the case, press the SET button on the receiver.
This stores the Fail-Safe positions permanently in the receiver. They can be
overwritten with new positions at any time by pressing the button again.
Receiver
SMART SX FLEXX