Tabla de contenido
Publicidad
6. Consejos Generaless
- Do not wear loose fi ng clothes while opera ng the unit. Do not use bracelets or any
other piece of jewelry. Have your hair always shortened and held up (use hair fishnets if
necessary) in a way it cannot reach any part of the machine. Roll up any loose sleeves.
- SKYFOOD is not responsible for any harm or injury caused by the negligent or inappropriate
use of this equipment by any operator. This equipment must be operated only by persons
whose age equals or exceeds 18 years old, in a safe and sound state of mind, free from the
influence of any kind of drugs and alcohol, that received proper training and instruc ons
regarding the correct opera on of this machine, that are wearing correct and authorized
safety clothes. All and any kind of modifica ons carried on and applied to this machine
immediately nullifies any kind of warranty and may result in harm and injuries to the
individuals opera ng this machine and to individuals that are located in the machine
surrounding areas while it is being operated.
- Under no circunstances place your hands in the moving parts of the machine while it
is being used. Make sure the machine has come to a complete stop before acessing the
processed ingredients.
34
2. Installa on and Pre Opera on
2.1 Installa on
In order to have a good performance, the Cheese and Coconut Graver is to be installed
onto a leveled surface approximately 850mm high.
Check if the voltage to which it will be connected is 110V or 220V.
In order to adjust the voltage, there is a voltage selector switch placed in the machine base
rear side. Take the rubber lid out and adjust the selector key to the appropriate voltage.
The cord has two flat pins and a round one ground wire. The three pins must be properly
connected before to start opera on.
2.2 Pre Opera on
Check if the Cheese and Coconut Grater is firm in its posi on.
Before using it, wash all the food-contact parts with water and neutral soap.
3 . Opera on
3.1 Star ng
MAXIMUM DIMENSIONS OF PRODUCT FOR PROCESSING:
HEIGHT = 3"5/32 WIDTH = 3"5/32 DEPTH = 3"5/32
Switch the machine OFF every me you wish to change a Blate. Wait un l the Disc
has completely stopped before opening the Head for feeding.
IMPORTANT
IMPORTANT
7
Publicidad
Tabla de contenido
