Attaching Grass Catcher Chute - Briggs & Stratton W3 Serie Manual Del Operador

Figure 2-5
b. Open the rear discharge door
using the door handle.
See Figure 2-6.
Handle
Figure 2-6
c. Place the grass catcher into
the slots on the rear discharge
support bracket.
See Figure 2-7 inset.
Figure 2-7
d. Pivot the grass catcher down so
that it rests over the rear opening
of the mower. See Figure 2-8. Let
go of discharge door so that it
rests against the grass catcher.
Figure 2-8
To remove grass catcher, hold open rear
discharge door on the mower. Lift grass catcher
up and off of the slots in the support bracket.
Release rear discharge door to allow it to close
rear opening of mower.

Attaching Grass Catcher Chute

1. Remove the vinyl cap on the deck stud in
front of the discharge opening.
See Figure 2-9.
Figure 2-9
2. On the side of the mowing deck, lift the
mulch plug. See Figure 2-10.
Figure 2-10
3. Insert the top of the chute into the
opening of the grass catcher support
bracket. See Figure 2-11a.
a
Figure 2-11
4. Pivot the chute towards the mowing
deck and over the opening in the side of
the mowing deck. See Figure 2-11b.
5. Secure the chute to the mowing deck
using the wing knob included in the
manual bag. Thread the wing knob onto
the deck stud. Hand tighten to secure
the discharge chute. See Figure 2-12.
NOTE:
On units with caster wheels, you may
need to pivot the front wheel to the side to
attach the wing knob.
Figure 2-12
S 2 — A & S
ECTION SSEMBLY ET
b
-U
7
P