Before Installation - hafele 959.23.040 Manual Del Usuario

Before installation:

Prior to mounting the door viewer, please make sure you have inserted the
batteries included.
Installation:
1. Remove the existing door viewer or drill a 14 mm hole in the door at eye
level. Insert the camera from the outside while inserting the washer
between the back of the lens and the door. Make sure that the arrow mark
on front of the camera points upwards. (FIG. 1)
2. Fit the holding plate over the end of the lens then screw the locking barrel
on to the threaded part of the camera and tighten (a tightening tool is
provided). This will hold the plate to the door. Make sure that the arrow on
the plate points upwards. (FIG. 2)
3. The data cable must be properly plugged into the back of the screen;
excess cable should be carefully positioned the groove in the back of the
screen.
Hook the screen onto the bracket at the top of the locking plate and secure
4.
the digital door viewer housing with the locking bolt. (FIG. 3)
6/16
Hang
Door
FIG. 1
FIG. 2
Screw
FIG. 3
FIG. 4