Care And Maintenance - Hauck iPro BABY Instrucciones De Manejo

• This is an i-Size ISOFIX INFANT RESTRAINT SYSTEM. It is approved to Regulation ECE
R129/02, not all vehicle manufacturer's handbooks list i-Size compatibility yet. This seat
and base are also approved for use in ISOFIX compatible vehicles. Please refer to the
vehicle manufacturer's website or consult your dealer.
• It will fit vehicles with positions approved as i-Size ISOFIX positions (as detailed in the
vehicle handbook), depending on the category of the child restraint and of the fixture.
WARNING ECE 44/04
• This product is suitable for children with a weight from 0 to 13 kg / a body size of
40-85 cm.
• Without base only suitable for use in vehicles equipped with a three-point safety belt as
approved by the ECE regulation No.16 or by other, comparable standards.
• All belts intended for fastening to the restrainer fittings in the vehicle must be tightened.
• The belts used to hold the child must be fastened tightly. The belts may furthermore
not be twisted.
• It is essential to ensure that the crutch belts are fastened as low as possible to ensure
that the crutch is retained properly.
• Replace the restrainer fittings if they have been subject to heavy loading due to an accident.
• WARNING: It is dangerous to change or supplement the restrainer fittings in any way
without approval from the competent authorities and to not precisely observe the
assembly instructions for restrainer fittings issued by the manufacturer.
• Do not expose the seat to direct sunlight.
• WARNING: Do not leave your child unattended in the restrainer fittings.
• Adequately secure items of luggage or other objects which could injure your child in
case of a collision.
• Do not use the child restrainer fittings without seat cover.
• The seat cover is an integral part of the restrainer fittings and may not be exchanged for
any other than that stated by the manufacturer.
• Rigid parts and plastic parts must not be jammed during assembly.
• Use the belt guide only as shown in the drawing.
• WARNING: This product does not comply to the requirements of EN 12790 for reclined
cradles! Never use this product as reclined cradle.
• Only use original spare parts which are offered or recommended by the manufacturer!

CARE AND MAINTENANCE

• After removing the foam wedge of insert, please store it somewhere that the child
cannot access it.
• Please wash the seat cover and inner padding with cold water under 30°C. Do not iron
the soft goods. Do not bleach or dry clean the soft goods.
W8 32