U-Tec Ultraloq UL3 Serie Guia De Instalacion página 12

Installing Handles
1. Press lever handles onto handle posts.
2. Test the mechanical operation of the lock by rotating handle from inside. The movement
of the bolt should be smooth and unobstructed. If the operation is not smooth, review the
previous steps to ensure proper installation.
If the handles are installed in the wrong direction, you need to remove them and re-install.
To remove the handle, you need to insert the screwdriver into the hole in the handle, push in
and hold. Then pull the lever handle out.
Handle Plug Position
The handle is plugged in correctly.
STEP
9
or
The handle is not fully plugged in.
- 11 -