In Case Of Black-Out; Door Unblocking Procedure; Resins Regeneration - Mocom Millwashing Manual Del Operador

IN CASE OF
BLACK-OUT
DOOR
UNBLOCKING
PROCEDURE
RESINS
REGENERATION
14
Upon the mains restore after a black-out, the unit will signal the event by showing on
the display the message "POWER FAIL" and store the washing program position
before the black-out.
At the mains restore, the unit can enter in Standby or Block status. From this condition
it is possible:

enter a START command to resume the cycle;

carry out the unblocking procedure and repeat the cycle.
In "Block" status, the door remains blocked; to unblock the door it is necessary to
perform the following procedure:
1. Press together START and STOP keys for 5 seconds
+
.
2. Press the program selection keys in sequence
.
2 1
The unit enters in "Standby".
I
F THE FAULT CONDITION PERSISTS FOR A MALFUNCTION
UNBLOCKED BUT THE UNIT STILL DOES NOT WORK
I
N THIS SITUATION CALL THE
When the unit detects a value of water hardness over the threshold (degradation of the
water softening function), the message "SALT LOAD" or "CLN" is shown on the
display.
In this case it is necessary to carry out the resin regeneration procedure. See Appendix
"C" - Maintenance.
NOTE
.
C S .
USTOMER UPPORT
,
THE DOOR IS