Operation; Initial Commissioning - Festool KS 60 E Manual De Instrucciones

English
[2-11] Cable winder with integral carry han­
dle
[3] Remove the transport safety device
[4] Insulated gripping surfaces (grey
shaded area)
The illustrations specified are located at the be­
ginning and end of the operating instructions.
6

Operation

6.1

Initial commissioning

WARNING
Unauthorised voltage or frequency!
Risk of accidents
► Observe the specifications on the ma­
chine's name plate.
► Observe country-specific regulations.
Ensure that the power tool is securely
positioned. Risk of tipping over. If re­
quired, observe the assembly instructions for
the MFT multifunction table or UG-KAPEX KS
60 underframe.
► Remove the transport safety device [3].
▷ Remove the protective sleeve from the
left-hand pulling rail
▷ Push the saw unit down, thus breaking
through the cable ties that are securing
it in place
▷ Remove the clamp from around the tilt
locking device
► Set up the machine and move it into the
working position.
6.2 Setting up and securing [5]
Pull out the mains plug before you carry
out any work on the machine.
Before securing, if required, install the A-SYS-
KS60 support legs (optional accessory). Thanks
to these support legs, the work surface on the
rotary base is at the same height as a Systainer
1. These Systainers mean that long workpieces
can then be supported [5].
24
.
.
.
You have the following options for
securing:
Secure the machine in such a way that it cannot
slip when you are working on it.
Screws[5A]: Use four screws to secure the ma­
chine to the work surface. Use the holes [5A-1]
at the four support points on the saw table to do
this.
Fastening clamps [5B]: Use fastening
clamps [5B-1] to secure the machine to the
work surface. The support points are used to
firmly secure the machine while taking the cen­
tre of gravity into consideration.
Clamping set (for MFT) [5C]: Use the clamping
set [5C-2] to secure the machine onto the Fes­
tool MFT 3 or MFT/Kapex (SZ-KS) multifunction
table. The hexagonal holes [5C-1] close to the
table extension on both sides are used for this.
UG-KAPEX KS 60 underframe[5D]: Observe the
installation instructions that are enclosed with
the underframe.
6.3 Transport
CAUTION
Risk of crushing
The saw unit may swing out/extend
► The machine must always be transported
in the transport position that has been pro­
vided for this purpose.
Risk of injury! The machine may slip out
of your hands when you are carrying it.
Always carry the machine with both hands, us­
ing the carrying handles [6] provided.
Securing the machine (transport position)
► Wind up the mains cable on the cable wind­
er [2-11] and use the cable clamp [2-1] to
secure it.
► Move the saw unit into the rear position and
lock it in place using the rotary knob [1-5].
► Swivel the saw unit into a vertical position.
▷ Loosen the star handle [2-9].
▷ Move the saw unit into a vertical posi­
tion.
▷ Tighten the star handle.
► Lock the saw unit in place.
▷ Press and hold the safety button [1-2].
▷ Move the saw unit downwards until it
reaches the limit stop.
▷ Pull the lever for the transport locking
device [1-6].
▷ Release the safety button.
The saw unit remains in the lower position.