Threading The Machine; Bobbin Setting; Removing The Bobbin; Setting Spool Of Thread On Spool Pin - Singer EM200 Manual De Instrucciones

BOBBIN SETTING

Be sure to use only SINGER® Class 15 transparent bobbins in
this machine.
R B
EMOVING THE OBBIN
1. Pull the bobbin cover latch to the right and remove the
bobbin cover.
2. Lift up the bobbin from the machine.
S S T
ETTING POOL OF HREAD ON
1. Pull up the left end of spool pin and set the felt washer and
the spool of thread on spool pin so that the thread unrolls
from the front of the spool.
2. Set the spool cap on spool pin as far as it will go.
a. The spool cap can be reversed in order to better
accommodate the size of smaller thread spools.
b. Use the small spool cap when you use cross wound
thread. Leave small opening between cap and spool as
illustrated.
c. Set the thread net over the spool if thread unrolls too
easily.
W
1. Hold thread in both hands and hook thread to the guide
2. Bring thread to the right and pass it through the thread
3. Insert thread through hole in bobbin and place the bobbin
4. Hold the end of the thread and push bobbin stopper to the
S P
POOL IN
5. After the bobbin winds a few turns, stop the machine by
6. Cut the thread near the hole, as illustrated.
7. Start the machine again.
8. When the bobbin is wound fully, the bobbin stopper will
9. Remove the bobbin from the spindle and cut thread with
12
T
HREADING THE
B
INDING THE OBBIN
from front opening.
guide from the back side. Pass thread under the tension
disc in a clockwise direction.
on bobbin winder spindle.
right. When the bobbin winding screen appears, press the
Start/Stop button on the screen to start winding.
pressing the Start/Stop button on the screen.
You can adjust winding speed by pressing "+" (faster) or "-"
(slower) button on the screen.
return to the left and stop winding.
the thread cutter.
M
ACHINE