AERMEC WRC1 Manual De Usario página 71

Heat set for 20°C
AUTO mode (68°F)
Set indoor unit
00
priority
Enable filter
00
cleaning alarm
Set delivery fin
standard open- 01
ing
Parameter
18°C
reserved
Parameter
22°C
reserved
Parameter
00
reserved
This parameter is used to define a heat set-point used in
AUTO mode (reminder: the auto mode is only available on
the master unit); to set the parameter, proceed as follows:
(1) Select the operating parameter "P38";
16°C~29°C
(2) Press the "MODE" button to enter the parameter modify
(61°F~84°F)
mode;
(3) Press the arrow buttons to set the required value;
(4) Press the "SWING/ENTER" button to return to the list of
operating parameters
This parameter is used to select the priority to be assigned to
the Indoor unit connected to the wired panel; this priority, if
the unit detects power drops, makes it possible to exclude
indoor units having normal priority in favour of those with
high priority; to set the parameter, proceed as follows:
00: normal priority
(1) Select the operating parameter "P43";
01: high priority
(2) Press the "MODE" button to enter the parameter modify
mode;
(3) Press the arrow buttons to set the required value;
(4) Press the "SWING/ENTER" button to return to the list of
operating parameters
This parameter is used to enable or disengage the filter
cleaning alarm (set using the specific function described in
this manual on page 25); to set the parameter, proceed as
00: filter cleaning follows:
alarm disengaged (1) Select the operating parameter "P46";
01: filter cleaning (2) Press the "MODE" button to enter the parameter modify
alarm enabled mode;
(3) Press the arrow buttons to set the required value;
(4) Press the "SWING/ENTER" button to return to the list of
operating parameters
This parameter is used to set the standard opening (i.e. the
position taken by the delivery fin once the unit is switched
on for heat or cool) of the indoor units fitted with motor-driv-
en delivery fins (inasmuch, canalised units are excluded); to
01: 25° opening set the parameter, proceed as follows:
02: 30° opening (1) Select the operating parameter "P49";
03: 35° opening (2) Press the "MODE" button to enter the parameter modify
mode;
(3) Press the arrow buttons to set the required value;
(4) Press the "SWING/ENTER" button to return to the list of
operating parameters
--- ---
--- ---
--- ---
EN
71