Warrantycard - SCHÜTTE 24260 Instrucciones De Montaje

Technical data
Hand shower: approx. 8.5 x 23.5 cm
Shower bar: Ø approx. 3 cm, length:
approx. 80 cm, max. 60 kg
holding force
Shower hose: approx. 150 cm, kink-resi-
stant, 1/2" (Ø approx. 1.9 cm)
standard connection
Bore hole size: Ø 8 mm
Bore hole depth: approx. 70 mm
Wall plug size: Ø 8 x 65 mm
Screw size: Ø 5 x 77 mm
Installation Instructions
• Check all connections carefully after first-time
use to make sure that they are tight.
• We do not assume any warranty for incor-
rect installation - in particular for subsequent
damages!
Note: A 23 mm spanner is required for the
installation of the shower hose. Please do not
use a pipe wrench!
Instructions for care
Sanitary taps require special care. Therefore,
please observe the following instructions:
• Chrome-plated surfaces are sensitive to lime-
dissolving agents, acidic cleaning agents and
all kinds of abrasives.
• Never clean coloured surfaces with abrasive,
corrosive, or alcoholic agents.
• Only clean your taps with clear water and a
soft cloth or a shammy.
Maintenance
• Please check all joints and connections for
leaks or visible damages at regular intervals.
• In case of any leaks or visible damages to
the fitting or connection hoses, these should
be immediately checked by a specialist and
replaced if necessary.
• Check the attachment of the support bar at
regular intervals.
Decommissioning
• Cut off the water supply before dismantling
the product.
• Pay attention to escaping residual water.
• Disassemble the product in the reverse order
of the assembly instructions.
 The illustrations are to be considered as
figurative representations, deviations of
the product are possible. Subject to
technical modifications.
WARRANTY CARD
The Franz Joseph Schütte GmbH, based in
Wallenhorst, shall take on a manufacturer's
warranty for the product you have procured
in accordance with the warranty conditions
stated below. Your legal warranty claims from
the purchase contract with the seller and
your legal rights shall not be limited by this
warranty.
Warranty conditions:
1. Scope of warranty
The Franz Joseph Schütte GmbH shall grant
a warranty for proper material qualities and
material processing in accordance with the
intended purpose as well as professional
assembly, tightness and function. The warranty
shall only apply for the country in which the
product has been procured.
Included within the scope of the warranty is a
guarantee, reduced to 1 year, for the durability
of non-high-gloss chrome-plated surfaces,
such as bronzed or coloured surfaces.
Excluded from the warranty are the following:
• Damages due to improper assembly, commis-
sioning and handling
• Damages due to external influences such as
fire, water and chemical influences
17