Future Shock; General Notes About The Future Shock Assembly; Installing The Fork And Future Shock Cartridge - Turbo CREO SL Manual De Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 84
Your CREO SL bicycle is equipped with a Future Shock steerer tube suspension system.

10.1. GENERAL NOTES ABOUT THE FUTURE SHOCK ASSEMBLY

WARNING! Due to the high degree of complexity of the Future Shock, proper assembly requires a
high degree of mechanical expertise, skill, training and specialty tools. Therefore, it is essential that
the assembly, maintenance and troubleshooting be performed by an Authorized Specialized Retailer.
WARNING! The Future Shock suspension and the proprietary components that work with the Future
Shock are specific to Specialized bicycles equipped with the Future Shock. Only use originally
supplied components and hardware at all times. Use of other components or hardware will
compromise the integrity and strength of the assembly. Future Shock specific components should
only be used on Specialized bicycles designed for Future Shock, even if they fit. Failure to follow this
warning could result in serious injury or death.
The Future Shock is available in damped and undamped models, depending on the bicycle. Installation is
the same for both models. In order to successfully install the Future Shock, it is very important to follow
the order of operations as outlined in this manual. Modifying the order of assembly will result in a longer
build process.

10.2. INSTALLING THE FORK AND FUTURE SHOCK CARTRIDGE

A video for the Future Shock cartridge is available by going to
specialized.com/video/306086210, or scanning the QR Code.
The Specialized Future Shock cartridge and headset are designed as an integrated unit
and are only intended for use with compatible frames and forks. Only use the specified
parts when assembling the front end of a CREO SL bicycle.
WARNING! The fork steerer tube is pre-cut to the size of the frame. Do not cut the fork, or use a
fork that is too short. Ensure that the size written on the fork matches the size of the frame.
INFO: The damped 2.0 Future Shock cartridge has only been tested and approved for use on bikes
that have the damped cartridge spec'd as original equipment.
10.1
Fig.10.1: Grease, then install the lower bearing (A) on the fork (B). Insert the fork into the head tube, then grease
and install the upper bearing (C) and compression ring (D) on the steerer tube.
CAUTION: Ensure that the compression ring slot is facing toward the front or rear of the bike. Do
not place the slot near the headset preload bolts.
25

10. FUTURE SHOCK

10.2
D
C
J
A
B
http://servicevideos.
F
E

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Creo sl expert evoCreo sl expert

Tabla de contenido