Turbo CREO SL Manual De Usuario página 28

Fig.10.2: Grease, then install the steerer tube collar bolt, washer and barrel. Install the steerer tube collar (E).
„
Fig.10.2: Apply blue loctite, then install the locator bolt (F) in the collar to lock the collar on the steerer tube.
„
Tighten until snug. Do not exceed 9.5 in-lbf / 1.0 Nm.
WARNING! To ensure that the collar and fork locator bolt holes are aligned with each other, place a
2 mm Allen key through the holes before installing and tightening the locator bolt. Ensure that the
headset adjustment set screws are backed out before installing the collar.
10.3
G
TALL HEADSET CAP
H
TALL HEADSET COVER
Fig.10.3: Place the headset cap (G-H) over the steerer tube collar.
„
Fig.10.4: Install 0-15 mm of steerer tube spacers (I) on the cartridge assembly (J). Apply carbon assembly
„
compound on the Future Shock, then insert the cartridge assembly into the steerer tube. Do not use grease.
WARNING! To ensure proper insertion of the Future Shock cartridge in the steerer tube, do not
install more than 15mm of spacers over the short or tall headset caps. Ensure there is no grease
between the steerer tube and the cartridge. Grease can cause the cartridge to slip, which can
result in a loss of control.
Specialized recommends the application of carbon assembly compound (or carbon paste)
between the cartridge and steerer tube to increase friction. See your Authorized Specialized
Retailer if you have any questions.
10.5
H
L
FLAT SURFACE
ALIGN THE FLAT
SURFACE AND THE
ARROW WITH THE
FRONT OF THE BIKE
10.4
10.6
ADJUSTABLE FUTURE
SHOCKS ONLY
4 mm
J
I
1.5 mm
26