Settings; Adjusting The Cutting Depth; Selecting The Saw Blade - Festool TSC 55 REB Manual De Instrucciones

< 15 %
Recommendation: Charge
battery pack before further
use.
LED red – lit continuously:
battery, electronics or motor
temperature is outside the
permitted range.
LED red – flashing: indicates a
general fault, e.g. incomplete
contact, short circuit, battery
pack faulty, etc.
7

Settings

WARNING
Risk of injury
► Remove the battery pack from the power
tool before performing any work on the
power tool.
7.1 Electronics
Smooth start-up
The electronically controlled smooth start-up
function ensures that the power tool starts up
smoothly.
Constant speed
The motor speed is electronically kept con­
stant. This ensures a uniform cutting speed
even when under load.
Speed control
You can continuously adjust the speed within
the speed range using the adjusting
wheel [1-10] (see Technical data). This enables
you to optimise the cutting speed to suit specific
surfaces (see Section
Current limiting
Current limiting prevents excessive current
consumption under extreme overload, which
can lead to a decrease in the motor speed. The
motor immediately restarts after the load is re­
moved.
Brake
The power tool omes with an electronic brake.
The saw blade is stopped electronically within
approximately two seconds of switching off the
machine.
Temperature cut-out
When exceeding a certain engine temperature
level, the machine power supply and speed are
capped. The power tool continues operating at
8.7 ).
reduced power to allow the ventilator to cool
the m-tor rapidly. The power tool resumes to
full performance automatically once the motor
has cooled sufficiently.
7.2

Adjusting the cutting depth

The cutting depth can be set at 0–55 mm at the
cutting depth stop [3-1].
The saw unit can now be pushed downwards as
far as the cutting depth that is set.
Cutting depth without guide rail
Max. 55 mm
Cutting depth with FS guide rail
+FS
Max. 51 mm
7.3 Setting the cutting angle
between 0° and 45°:
► Unscrew the rotary knobs [4-1].
► Swivel the saw unit to the desired cutting
angle [4-2].
► Tighten the rotary knobs [4-1].
Both positions (0° and 45°) are set at
the factory and can be readjusted by
the customer service team.
When making angled cuts, slide the view­
ing window/splinter guard to the highest
position.
To undercut -1° and 47°:
► Swivel the saw unit to the end position (0°/
45°) as described above.
► Pull out the release button [4-3] slightly.
► For -1° undercuts, also pull the release
button [4-4].
The saw unit engages in the -1°/47° position.
► Tighten the rotary knobs [4-1].
7.4

Selecting the saw blade

Festool saw blades are identified by a coloured
ring. The colour of the ring represents the ma­
terial for which the saw blade is suited.
Colour
Yellow Wood
Red Laminated wooden pan­
els
Green Eternit fibre cement
panels
Blue Aluminium, plastic
English
Material Symbol
21