Midland Enerjump Mini Jump Manual De Usuario página 15

You will see one of the following options:
beep beep
A.
A. Green led on: the connection is correct and the circuit is wor-
beep beep
beep beep
king. You can turn on the engine.
B. Flashing green led and buzzing: the battery of your vehicle has
a low voltage. Press the "BOOST" key, the green led lights up.
Turn on the engine within 30 seconds.
C. Red led on and buzzing: wrong connection. Remove the
clamps and connect them again; wait till the green light is on
to turn the engine.
D. All leds are off and no buzzing: the battery of your vehicle is
damaged. Make sure the connection is correct and then press
the "BOOST" key. The green led lights up. Now you can turn on
the engine with 30 seconds.
• Turn on the ignition key to start the vehicle.
• If the engine starts, disconnect the red and black clamps from
the vehicle's battery terminal.
• Leave the vehicle's engine running for a few minutes.
• If the vehicle does not start on the first trial, wait for 1/2 minutes
before trying to start the vehicle again.
beep beep
beep beep
B. C.
13
beep beep beep beep
beep beep
D.