Setting / Adjustment; Mains Connection - Mafell KSP 85 Fc Manual De Instrucciones

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

Instructions on the use of personal protective

equipment:

- Always wear ear protectors during work.

- Always where a dust mark during work.

Instructions on operation:

- Do not reach with your hands into the sawing area

and do not touch the saw blade. With your other

hand, support the supplementary handle or the

motor casing.

- Do not reach under the workpiece.

- Adapt the cutting depth to the workpiece thickness.

- Never support the workpiece in your hand or over

your leg. Secure the workpiece against a sturdy

support.

- Only hold the device by its isolated handle

surfaces when carrying out work during which the

cutting tool could hit hidden power cables or its

own connection cable.

- Always use a limit stop or a straight edge guide for

longitudinal cutting.

- Always use correctly sized saw blades with

matching receiving bore (e.g. star-shaped or

round).

- Never use damaged or incorrect saw blade

washers or screws.

- Hold the saw with both hands and bring your arms

into a position where you are able to resist the

backlash forces. Always keep to the side of the

saw blade. Never bring the saw blade in line with

your body.

- If the saw blade gets jammed or sawing is

interrupted for some other reason, release the

on/off switch and keep the saw steady in the

material, until the saw blade has come to a

complete standstill. Never try to remove the saw

from the workpiece or to pull it backwards while the

saw blade is still moving or while a backlash could

occur.

- If you would like to restart a saw that is stuck in the

workpiece, centre the saw blade in the saw slit and

check whether the saw teeth are stuck in the

workpiece.

- Support large plates to reduce the risk of backlash

caused by a jammed saw blade.

- Do not use any blunt or damaged saw blades.

- Before starting to saw, tighten the cutting depth

and cutting angle adjustments.

- Be especially careful when making a "plunge cut"

into a concealed area, e.g. into an existing wall.

- Prior to every use, check whether the lower saw

guard is closing properly. Do not use the saw if the

lower saw guard is not freely movable and does

not close immediately. Never clamp or tie down the

lower saw guard in an open position.

- Check the function of the spring for the lower saw

guard. Have the device serviced if lower saw guard

and spring do not work properly.

- Only manually open the lower saw guard for

special cuts, such as "plunge and angle cuts".

Open the lower saw guard using the retracting

lever and release the lever as soon as the saw

blade has penetrated the workpiece.

- Do not place the saw on the work bench or on the

floor without the lower saw guard covering the saw

blade.

- Use the saw blade that matches the riving

knife/splitter

- Adjust the riving knife / splitter as described in the

operating instructions.

- Always use the riving knife / splitter except for

"plunge cuts".

- For the riving knife / splitter to function, it has to be

located in the saw slit.

- Never operate the saw with a bent riving knife /

splitter.

- Examine the workpiece for foreign objects. Never

attempt to cut into nails or other metal objects.

Instructions on service and maintenance:

- Regularly cleaning the machine, especially the

adjusting devices and guides, constitutes an

important safety factor.

- Only original MAFELL spare parts and accessories

may be used. Otherwise the manufacturer will not

accept any warranty claims and cannot be held

liable.