Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

CASTER SYSTEM
PLASTIC TANK WITH CASTER FEET
You will find four caster feet, four casters and four screws with your vacuum. Assemble as
follows:
1. With cord disconnected from receptacle and tank cover removed, turn tank upside down
so that bottom is facing up.
2. With front of tank facing you, take caster feet marked with the
letter A and place in slots on left front and right rear of tank
also marked with the letter A. Secure with screws provided.
3. Take caster feet marked with the letter B and place in slots on right front and
left rear of tank also marked with the letter B. Secure with screws provided.
4. If flat washers are included in hardware package place flat washer over stem of caster before installing
casters into feet. NOTE: Flat washers are not required with all units.
5. Insert casters into feet by placing stem of caster into holes provided. Apply
pressure and twisting motion until casters snap into place. Return tank to
upright position.
TOOL HOLDER
(Not standard with all models)
If your unit came with a tool holder, follow these instructions to install it.
1. If your tool holder looks like the one shown to the right, assemble as follows:
a. Set tank cover onto the tank. Position with back of tank cover facing you.
b. Take tool holder and place tabs on tool holder into slots on back of
tank cover.
c. Press down until tabs snap into place. Continue to step 3.

ASSEMBLY

Screw
Caster
Foot
Screw
Caster
Caster
Foot
PAGE 5
Caster
Foot

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Ssp16 serie

Tabla de contenido