Leckey Mygo Instrucciones De Usuario página 48

10.8 Adjusting the
upper leg supports
The upper leg supports will be set at the
minimum position on arrival. Set the depth
before placing the child in the seat.
Fine adjustment is possible afterwards but
is restricted by the user's weight. To achieve
the correct position measure the length
from the child's lower back to the back of
their knee.
For Size 1 adjust the supports to the
desired position using the locking lever (A)
underneath the seat base. To adjust, press
the locking button and release. Keep the
supports pointing straight forward at this
time unless wind sweeping or adduction,
abduction must be accommodated, in which
case set the angle accordingly using the
locking lever again.
The supports can be readjusted once the
child has been placed in the chair.
A
For Size 2, loosen the locking levers under
the seat and slide leg support to required
position. Keep the supports pointing
straight forward at this time unless wind
sweeping or adduction, abduction must be
accommodated, in which case set the angle
accordingly. Retighten bolt. To increase the
angle further, remove bolt and move leg
angle to wider setting. Insert bolt into second
slot (B) and tighten.
A
B B