Topcom BABYTALKER 3000 SEDS Manual De Usuario página 8

11 Troubleshooting
This section provides important instructions for localising and correcting faults.
Follow these instructions in order to avoid hazards and damage.
11.1 Safety Instructions
DANGER
Danger of death due to electric current!
• Unplug the power cable before attempting to correct a problem.
CAUTION
Hazard due to improper repairs!
Improper repairs can expose users to serious hazards and cause damage to the equipment.
• Never attempt to modify or repair the equipment.
• Always have repairs to equipment or cables performed by a specialist or the service centre.
• If you suspect that the equipment is damaged (e.g. if it has been dropped), you must have it checked
by a specialist before you use it again.
11.2 Problem causes and remedies
The following table is intended to help you pinpoint and correct minor problems:
Problem
The parent unit
rechargeable battery
pack is not charging
Unable to switch the
parent unit on.
You hear the twin-tone
audible warning and
the link LED
13
flashing continuously.
The parent unit does
not play back the
sounds picked up by
the baby unit
Limited range and
interference during
transmission
The equipment emits a
high-pitched whistle
11.3 Registering the parent unit with the baby unit
If the baby unit night light is flashing and/or no connection can be made between the parent unit and the baby
unit (flashing green LED
• Check that the AC mains adapter of the baby unit is connected and plugged into a mains
socket and that the batteries in the parent unit are charged.
8
Possible cause
Charging station plug not inserted
Dirty contacts
The rechargeable battery pack no
longer operates
The rechargeable battery pack is
not charged
Equipment defective
Baby unit not switched on
The parent unit and baby unit are
is
too far apart
The parent unit is not registered with
the baby unit
The volume setting of the parent
unit may be too low or switched off
entirely.
The range of the equipment
depends on the surroundings.
Steel structures and concrete walls
can impair transmission.
The parent unit and baby unit are
too close together
on the parent unit), the parent unit needs to be registered with the baby unit.
13
Babytalker 3000 SEDS
Remedy
Insert plug
Clean the battery terminals and
charging station contacts with a soft
cloth
Replace the battery pack
Charge the battery pack
Contact customer service
Switch the baby unit on
Reduce the distance between the
parent unit and the baby unit
Register the parent unit with the
baby unit (see page 8)
Increase the volume setting of the
parent unit
Avoid obstacles as far as possible.
Increase the distance to at least
2 metres