Connecting The Electrical Power To Magicspeed - Dometic MAGICSPEED MSBE 7 Instrucciones De Montaje

Connecting the electrical power to MagicSpeed

➤ Lay the connection cable to the cable set.
➤ Replace the cover on the steering column.
7 Connecting the electrical power to MagicSpeed
7.1 General notes on laying cables
I
NOTE
• As far as possible, use original ducts for laying the cables, or other suitable options,
such as panelling edges, ventilation grilles or dummy plugs. If no openings are
available, you must drill holes for the cables. Check beforehand that there is
sufficient space on the other side for the drill head to come out.
• Cables and connections that are not properly installed will cause malfunctions or
damage to components. Correct installation of cables and connections ensures
lasting and trouble-free operation of the retrofitted components.
Therefore, please observe the following instructions:
• To prevent damage to the cables, when laying them, ensure that they are far enough away from
hot or moving vehicle components (exhaust pipes, drive shafts, light systems, fans, heater etc.).
• Wrap insulating tape around every connection on the cable (even inside the vehicle).
• When laying electric connections (fig. 3, page 3), ensure that
– They are not kinked or twisted
– They do not rub on edges
– They are not laid in sharp-edged ducts without protection
• Protect every hole you drill against water penetration, e.g. by using a cable with a sealant and
by spraying the cable and the the cable sleeve with sealant.
12
MagicSpeed MSBE7
EN