The Serial Interface; Available Pressure Sensors - WIKA CPH6200-S1 Manual De Instrucciones

Hand-Held Pressure Indicator
CPH6200-S1 / CPH6200-S2
Clear data:
When the ´Store/Quit´ key is pressed for 2 seconds, the logger opera-
tion will be called.
The display will show:
By pressing the key ´Max´ or key ´Min´ the display will change to:
When ´Store/Quit´ is pressed, the choice for clearing the logger memory
will be displayed:
The selection can be made by key ´Max´ or key ´Min´.
´Store/Quit´ enters the choice.

4. The serial interface

For data transfer to a computer there are two electrically-isolated inter-
face adapters available for the connection of the CPH6200 to a RS-232
or USB interface (USB-driver necessary).
WIKA's Data logger evaluation software GSOFT (see current CPH6200
price list) is used to display the data. To avoid transmission errors, there
are several security features implemented (e.g. CRC).

5. Available pressure sensors

The instrument has been designed so that all sensors model CPT6200
can be connected without the need for any configuration or recali-
bration. There is therefore a wide range of interchangeable sensors
available; with ranges of up to 1000 bar (see current price list for model
CPT6200 pressure transmitters).
WIKA Operating Instructions Hand-Held Pressure Indicator
clear
all recordings
clear the last
recording sequence
clear nothing
(cancel menu)
21
GB