Prior To Use - WMF STELIO Instrucciones De Uso

Prior to use

Please read the instruction manual carefully. It contains important information about using the
device, as well as safety and maintenance advice. Please store it carefully and if necessary pass it on to
subsequent users. The device should only be used for its designated purpose in accordance with these
usage instructions. Please pay attention to the safety instructions during use.
Technical data
Rated voltage:
Power consumption:
Protection class:
Safety information
▪ This appliance is only suitable for coffee beans.
▪ The bean hopper's maximum filling quantity is 150 g.
Warning! If collection container for the coffee powder is overfilled, the device could stop. Therefore
empty the collection container in good time.
▪ Do not pull or clamp the cable across sharp edges. Do not allow it to hang down and protect it
from heat and oil.
▪ Do not place the device on hot surfaces such as hotplates etc, and do not operate close to naked
flames.
▪ Do not remove the plug from the socket by the cable or with wet hands.
▪ Cease operating the device and unplug it immediately if:
⋅ the device or the mains cable is damaged;
⋅ you suspect a defect after dropping the device etc.
In these instances send the device for repair.
▪ Do not immerse the device in water.
▪ No liability is assumed for possible damage through misappropriation, incorrect operation or
negligent repair. Furthermore warranty payments are excluded in such events.
▪ The device is not suitable for commercial use.
Start-up
▪ Remove all packaging and thoroughly clean the appliance prior to first use (see "Cleaning and care"
section).
▪ Slide the collection container (8) with lid (7) into the appliance until you hear it lock into place.
▪ Remove the lid of the bean hopper (1) and fill with your desired type and quantity of coffee beans
(max. 150 g).
Attention! This coffee grinder is only intended for grinding coffee beans. The use of other grinding
material, such as freeze-dried or caramelised coffee beans, poppy seeds, nuts, sugar, etc., is impro-
per use and will void your warranty.
▪ Place the lid back on the bean hopper.
▪ Set the desired grinding setting (see "Grinding degree" section).
▪ Select the desired number of cups with the portion selection control knob (5). You can select
between two and ten cups.
Note: The cup amounts given on the portion selection switch (5) are for orientation purposes only.
Different coffee types, cup sizes, water hardness levels and personal tastes may call for different
settings.
▪ Connect the mains plug to a socket.
▪ The grinding processor begins when you press the on/off button (4).
220-240 V~ 50-60 Hz
110 W
II
9