Miele STB 201 Instrucciones De Manejo página 9

The Turbobrush is intended for
brushing and cleaning cut pile
carpeting. In addition the Turbobrush
can be used on hard-wearing smooth
flooring surfaces. Four rollers maintain
the brush 1.5 mm away from the floor.
The normal floorhead or the Miele
parquet floorbrush should be used to
clean delicate hard flooring, e.g.
parquet flooring and floor surfaces
which are susceptible to scratching.
^ Pass the Turbobrush slowly
backwards and forwards over the
carpet or floor covering to achieve
the best effect.
For carpets with fringes always draw
the Turbobrush from the carpet across
the fringe towards the rest of the floor
for a flat effect.
The following should not be vacuu-
med using the Turbobrush:
– Floor surfaces with a variable or
uneven profile. The brush might
come into contact with the floor and
cause a damage.
– Carpets such as saxony with very
long pile, berber and sheepskin
rugs, and valuable hand-knotted car-
pets, e.g. Persian and similar.
There is a danger that threads can
be pulled out.
When in doubt please consult your
carpet specialist.
G
Use
9