System Master Sheet; Manufacturer; Purpose - Nussbaum POWER LIFT HF 3S 3000 Instrucciones De Servicio

2

System master sheet

2.1

Manufacturer

Otto Nußbaum GmbH & Co.KG
Korker Straße 24
D-77694 Kehl-Bodersweier
2.2

Purpose

The lift is a lifting tool for raising vehicles with a total weight of (* see list) in normal workshop operation at a
maximum load distribution of (2:3**) (1:3***) in or against the drive-in direction A single load from only one
or two lifting arms may not happen.
Set up of the standard lift in explosion endangered workshops and humid spaces (e.g. washing halls) is
prohibited.
Lift operation is done directly on the operating column (see Data sheet).
After construction and maintenance changes on load carrying parts the lift must be inspected afterwards
by a specialist who approves the changes. If the set up location is changed, the lift must be checked
again by a specialist and changed approved.
(*)Load carrying capacity of the POWER LIFT HF 3S series:
POWER LIFT HF 3S 3000** = HYMAX HF 3S 3000 = 3,000 kg
POWER LIFT HF 3S 3500** = HYMAX HF 3S 3500 = 3,500kg
POWER LIFT HF 3S 4000 *** = HYMAX HF 3S 4000 = 4,000 kg
Lifting arm variants
Standard arms
MINI-MAX arms (MM)
Universal Lifting arm
DT* Lifting arm
Sport Cars lifting arm
(SC)
*DT = Double telescope lifting arms (previously MB arms)
OPI-POWER LIFT HF 3S 3000-4000 - HYMAX HF 3S 3000-4000 -V1.1-DE-EN-FR-ES-IT
POWER LIFT HF 3S 3000
HYMAX HF 3S 3000
590 – 900 mm
940 – 1495 mm
560 – 1030 mm
1000 – 1545 mm
–
480 – 870 mm
940 – 1495 mm
–
POWER LIFT HF 3S 3500
HYMAX HF 3S 3500
505 – 823 mm
940 – 1495 mm
–
–
570 – 1160 mm
940 – 1495 mm
590 – 865 mm
840 – 1380 mm
POWER LIFT HF 3S 4000
HYMAX HF 3S 4000
600 – 900 mm
1130 – 1840 mm
635 – 1065 mm
1130 – 1840 mm
570 – 1160 mm
1130 – 1840 mm
–
–
65