Main Unit - CAMPAGNOLO Ergobrain Manual De Uso

Bracket
Attach the arm next to the handlebar stem (right side). Tighten the screw.
Attach the bracket to the arm and tighten the screw. Adjust the angle and the
position of the arm so that the main unit comes to the center of the handlebar.
SPD/CDC Sensor Wire
The connectors of the SPD sensor and CDC sensor are inside the bracket.
When detaching the CDC sensor wire, or when replacing either of the wires,
follow the procedures below:
1. Remove the screw at the bottom of the bracket. Then remove the connector
cover.
2. Take off the connector. If you do not replace it with a new one, fill the empty
space with the spacer and reinstall the connector cover with the screw.

Main Unit

Slide the main unit down from upside. To remove it, pull the unit upward.
Warning: do not short-circuit the contacts of the main unit.
- 5
UK
SPD
CDC