Rapid 5050e Manual Para El Usuario página 19

gb
ACCESSORIES
Pedal intended for trigging the stapling. When the pedal is connected, the
internal trigger is disabled.
Support table for the object to be stapled.
INSTALLATION
The Rapid 5050e/5080e is installed as follows:
1 Position the machine on a stable horizontal surface. The machine shall be placed on a
smooth and clean surface so that the feet are fixed to the surface.
2 Check that the correct adapter is used. See data plate (B)
3 Insert the adapter's plug into the electric supply and the low voltage socket (n)
to the machine.
OPERATION
Replacing the staple cassette
When only 19 staples are remaining in the cassette, the warning light (H)
changes from green to red. Replace the staple cassette (G) as follows.
See fig. 2 and 3:
Fill the machine with staples when required as shown in figure 3:
1 Press the visor (F) locking knob (E) and remove the visor.
2 Hold the cassette in its upper part and pull it straight horizontally outwards.
3 Mount a new cassette in the opposite order.
4 Mount the visor. Check that its front part is correct positioned and that the locking
knob snaps up.
5 The warning light shows green and the stapling can start.
Adjusting the trigger position
See fig. 3
The distance between the staple and the edge of the stapling object is
determined by adjusting the staple depth with the lever (k). The distance is
read at the scale above the lever.
note that corner stapling and edge stapling can require different positions.
33
Stapling
Stapling is performed as follows:
1 Check that the lever (k) is adjusted for the correct stapling depth.
2 Connect the machine to the electrical supply. The warning light (H) will show green.
Warning: Only the stapling object is allowed to be placed under the visor.
3 Move the stapling object forward to the stapling position so that the trigger is pushed in.
4 Disconnect the machine from the electrical supply when the stapling is performed.
MAINTENANCE
Checking safety functions
One of the safety checks that should be done every day before the machine
is used is to check on the visor's safety function.
Check the visor's safety switch as follows:
1 Connect the machine to the electrical supply.
2 Remove the visor by pressing its knob.
3 Test whether or not the machine will staple a piece of paper with the visor removed.
If the machine operates without the visor it must be disconnected immediately and sent for
repair.
Cleaning
The machine should be cleaned when required as follows:
1
Remove the adapter by disconnecting its cables.
2
Clean the machine as required by blowing away dust and paper remnants.
3 If the machine is heavily soiled it should be cleaned with a moist rag.
4 If there are loose staples in the machine, lift it up and turn it in different positions when
shaking it. The staples will fall out through the holes in the bottom of the machine.
gb
34