Safety Information; Some Do's And Don'ts On The Safe Use Of Equipment - Tangent Alio Junior Dab+ Manual Del Usuario

Safety Information

Some Do's and Don'ts on the Safe Use of Equipment

This equipment has been designed and manufactured to meet international safety
standards but, like any electrical equipment, care must be taken if you are to obtain the
best results and safety is to be assured.
DO read the operating instructions before you attempt to use the equipment.
DO ensure that all electrical connections (including the mains plug, extension leads and
inter-connections between the pieces of equipment) are properly made and in accordance
with the manufacturer's instructions. Switch off and withdraw the mains plug before
making or changing connections.
DO consult your dealer if you are ever in doubt about the installation, operation or safety
of your equipment.
DON'T remove any fixed cover as this may expose dangerous voltages.
Overheating will cause damage and shorten the life of the equipment.
DON'T allow electrical equipment to be exposed to dripping or splashing, or objects filled
with liquids, such as vases, to be placed on the equipment.
DON'T place hot objects or naked flame sources such as lighted candles or nightlights on,
or close to equipment. High temperatures can melt plastic and lead to fires.
DON'T use equipment such as personal stereos or radios so that you are distracted from
the requirements of traffic safety.
DON'T listen to headphones at high volume level, do so may damage your hearing.
DON'T leave equipment switched on when it is unattended unless it is specifically stated
that it is designed for unattended operation. Switch off using the switch on the equipment
and make sure that your family knows how to do this. Special arrangements may need to
be made for infirm or handicapped people.
DON'T continue to operate the equipment if you are in any doubt about if it's working
normally or if it's damaged in any way. Switch it off and withdraw the mains plug and
consult your dealer.
ESD Remark: In case of malfunction due to electrostatic discharge just reset the product
(reconnection of power source may be required) to resume normal operation.
NOTE: Do not open any covers and do not repair by yourself. Qualified personnel must
carry out repair work.
4 (GB)