Rear Panel Connections And Controls Pa410 - Arcam PA720 Manual De Instrucciones

Rear Panel Connections and Controls PA410

Ensure that the voltage
selected matches the local
POWER INLET
110-120V/220-240V ~ 50/60Hz
500W MAX
POWER INLET
Connect the correct mains cable
here.
00_SH299_EN-FR-DE-NL-ES-RU-IT-CN-KO.indb 9 00_SH299_EN-FR-DE-NL-ES-RU-IT-CN-KO.indb 9
RS232
VOLTAGE SELECT This connection allows for remote control
from a third-party home automation
system or computer.
power supply. See "Network and RS232" on page EN-10.
NET RS232
SUPPLY
VOLTAGE
SWITCH POSITIONS
115 = 110 - 120V ~
230 = 220 - 240V ~
NETWORK
Connect your wired local network to one port.
The second port can be used to connect to
other devices
See "Network and RS232" on page EN-10.
USB
Trigger OUT allows the PA410 to control the power state of other connected
For software upgrades only. See
"USB" on page EN-10.
IN4 IN3 IN2
TRIGGER IN
USB
5V 100mA
TRIGGER OUT
OUT4 OUT3 OUT2
(12V 100mA)
PRE-AMPLIFIER INPUTS
Connect the phono outputs of your
pre-amplifier.
See "Connecting Sources and
Loudspeakers" on page EN-13.
PRE-AMPLIFIER OUTPUT
OUT1 to OUT4 provide a copy
of the signal applied to the
IN1 to IN4 phono sockets.
Note: This is a passive output,
no additional filtering or
amplification is applied.
EN-9
TRIGGER IN / OUT
Trigger IN allows the PA410 to be turned on or off by an external source.
equipment
See "Trigger IN/OUT" on page EN-10.
CH4 CH3 CH2
IN1
CLASS 2 WIRING
OUT1
4-16 OHMS
SPEAKER TERMINALS
See "Connecting Sources
and Loudspeakers" on
page EN-13.
Please read the sections "Placing The Unit",
"Power" and "Interconnect Cables" on page
EN-6 before connecting
amplifier!
EN
CH1
your PA410
29/01/2020 13:11:33 29/01/2020 13:11:33