Connecting Sources And Loudspeakers - Arcam PA720 Manual De Instrucciones

Connecting Sources and Loudspeakers

PA720
Connect the RED positive speaker terminal labelled
CH1 to CH7+ to the positive terminal of your speaker.
Similarly, connect the BLACK negative speaker terminal
of the same channel to the negative terminal of your
speaker.
Repeat this process for the other speakers, using the
same respective input and speaker terminals for each
channel.
NOTE: All the channels are identical so there is no
requirement to connect specific AVR output channels
to specific amplifier channels.
Notes On Making Speaker Connections
Do not make any connections to any amplifier while it is switched on. We recommend
that your amplifier is completely disconnected from the mains supply before starting.
Before switching your amplifier on for the first time after connecting to speakers, please
check all connections thoroughly. Ensure that bare wires or cables are not touching
each other or the amplifier's chassis (which could cause short circuits), and that you
have connected positive (+) to positive and negative (–) to negative. Be sure to check
the wiring for both the amplifier and the speaker.
After making connections: switch the amplifier on then gradually increase the volume
to the required listening level.
If you are unsure as to how your system should be connected, please contact your
Arcam dealer who will be happy to help you.
00_SH299_EN-FR-DE-NL-ES-RU-IT-CN-KO.indb 13 00_SH299_EN-FR-DE-NL-ES-RU-IT-CN-KO.indb 13
AV860
PREAMP OUT
FL C SL
FR SUB 1 SR
IN7 IN6 IN5
PA720
Note: Single channel shown for
clarity OUT7 OUT6 OUT5
HF HF
LF LF
EN-13
DIGITAL AUDIO
SAT PVR
L
ETHERNET FM/DAB
USB 5V 1A
R
BD CD STB AV
HEIGHT1 HEIGHT2
L
R FL C SL SBL HEIGHT 1 L HEIGHT 2 L
SUB 2
PREAMP OUT
FL C SL SBL
FR SUB 1 SR SBR HEIGHT 1 R HEIGHT 2 R
~50/60Hz 50W MAX
BALANCED OUTPUTS
115
SWITCH POSITIONS
FR SUB 1 SR SBR
115 = 110 - 115V~
230 = 220 - 240V~
SBL
FL C SL SBL
SBR
FR SUB 1 SR SBR
BALANCED OUTPUTS
IN7 IN6 IN5 IN4 IN3 IN2
IN4 IN3 IN2 IN1
OUT4 OUT3 OUT2 OUT1
CH7 CH6 CH5 CH4 CH3 CH2 CH1
CLASS 2 WIRING 4-16 OHMS
HF HF HF
LF LF LF
23425
TRIG Z1 Z1 IR
DC 6V
RS232
1.2A MAX
TRIG Z2 Z2 IR
POWER INLET
230
Note: Unit should be
connected via RCA
or XLR. Both versions
shown for illustrative
HEIGHT 1 L HEIGHT 2 L
purposes only.
INPUT
RCA XLR
HEIGHT 1 R HEIGHT 2 R
IN1
TRIGGER IN
USB
5V
INPUT RS232 NET 100mA
RCA XLR
TRIGGER OUT
(12V 100mA)
POWER INLET
SUPPLY
VOLTAGE
110-120V/220-240V~
SWITCH POSITIONS
50/60Hz 1.5kW MAX
115 = 110 - 120V ~
230 = 220 - 240V ~
HF HF
LF LF
29/01/2020 13:11:34 29/01/2020 13:11:34
EN