Adding An Event - Lutron QS Guía De Instalación Y Funcionamiento

Timeclock Operation

Adding an Event

Main menu
1. Enter programming mode.
2. Use the Master buttons to highlight "Timeclock" and press the OK
Timeclock
Timeclock
button to accept.
Scene setup
3. Use the Master buttons to highlight "Add events" and press the
OK button to accept.
4. Use the Master buttons to highlight the recurrence for this event:
Timeclock
day of the week, holiday, weekdays or weekends. Press the OK
button to accept.
View events
5. Use the Master buttons to highlight the type of the event (fixed time of day or a relative time to sunrise or
Add events
sunset). Press the OK button to accept.
6. For a fixed-time event, use the Master buttons to highlight the hour for your event to begin; press the OK
button to accept. Repeat for the minutes.
Add events
For a relative-time event, use the Master buttons and the OK button to set the hour, then the minutes relative
to sunrise or sunset (maximum of 1 hour, 59 minutes before or after sunrise or sunset).
Monday
7. Use the Master buttons to highlight the desired action for the timeclock event:
• Scenes 1-16, Off
• Window Treatment Groups 1-3 open, preset, or close
• Start/End Afterhours
Add events
8. The info screen will confirm that your event has been saved.
9. Repeat steps 4 through 9 for additional events.
Time of day
10. Exit programming mode.
Set time
: 00 AM
08
Add events
Scene
Scene 1
®
(continued)
1
Saved
2 3 4 5 6
QS Timeclock Installation and Operation Guide 16
Master
buttons
OK
OK
button
Timeclock
(back) button