Measurement Reset - MZ electronic EV-030 Instrucciones De Uso

Instrument calibration
Before using the instrument the following parameters must be set:
•
choice of unit of measurement (metres or feet);
•
detection of type of sensor (Standard or Project);
•
gipsy diameter setting (default value 33 cm) or reduction factor (default value 57) or division
factor;
Standard and X.. Project series
sensor menu
Sensor Calibrat
Barb. Circ.
D i v i s o r f a c t .
E x i t
Use
Press the (ON) key to activate controls and to switch on the display lighting. The display lighting
switches off 30 seconds after the last command given (adjustable default time – see "BkLight Time").
Press key (UP) to control the anchor ascending.
Press key (DOWN) to cast anchor.
When any key is released (UP or DOWN) the corresponding action is stopped.

Measurement reset

To reset the measurement count simultaneously press the
three seconds.
Measurement reset may also be performed in the Measurement menu by selecting "Yes" in the Reset
Measure row.
Automatic casting of the anchor
This function must be enabled in the Alarms and Functions menu (disabled by default).
Select the row "Auto Down" and set the value at which the anchor must stop. Then press the
and (DOWN) keys for at least three seconds. Once anchor casting has commenced, release the keys.
EV-030
3 3 . 0
1
Alarms & Functi
U p A l a r m
A u t o D o w n
L o a d D e f a u l t
E x i t
1000 – 1500 –2000 W Project series
sensor menu
Sensor Calibrat
Red. Factor
E x i t
(ON) and the
3 . 0
O f f
N o
29
English
5 7 . 0
(UP) keys for at least
Rev. 13 – 2013
(ON)