Additional Safety Rules - Makita BGA452 Manual De Instrucciones

ENGLISH
1. Button
2. Red part
3. Battery cartridge
4. Shaft lock
5. Slide switch
6. Indication lamp
7. Wheel guard
8. Bearing box
SPECIFICATIONS
Wheel diameter
Spindle thread
No load speed (min
Overall length
Rated voltage
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Note: Specifications may differ from country to country.
Symbols
The following show the symbols used for the tool. Be sure
that you understand their meaning before use.
............. Wear safety glasses.
Intended use
The tool is intended for grinding, sanding and cutting of
metal and stone materials without the use of water.
4
Explanation of general view
9. Screw
10. Lock nut
11. Depressed center grinding wheel/
Multi-disc
12. Inner flange
13. Lock nut wrench
14. Diamond wheel
15. Inner flange
Model
-1
)
Net weight

ADDITIONAL SAFETY RULES

END002-1
1. Always use eye and ear protection. Other personal
protective equipment such as dust mask, gloves,
helmet and apron should be worn.
2. Keep guards in place.
3. Use only wheels with correct size and wheels hav-
ing a maximum operating speed at least as high as
the highest No Load Speed marked on the tool's
nameplate. When using depressed center wheels,
be sure to use only fiberglass-reinforced wheels.
4. Check the wheel carefully for cracks or damage
before operation. Replace cracked or damaged
wheel immediately.
5. Observe the instructions of the manufacturer for
correct mounting and use of wheels. Handle and
store wheels with care.
6. Do not use separate reducing bushings or adap-
tors to adapt large hole abrasive wheels.
7. Use only flanges specified for this tool.
8. Do not damage the spindle, the flange (especially
the installing surface) or the lock nut. Damage to
these parts could result in wheel breakage.
9. For tools intended to be fitted with threaded hole
wheel, ensure that the thread in the wheel is long
enough to accept the spindle length.
10. Before using the tool on an actual workpiece, test
run the tool at the highest no load speed for at
least 30 seconds in a safe position. Stop immedi-
ately if there is any vibration or wobbling that
could indicate poor installation or a poorly bal-
anced wheel. Check the tool to determine the
cause.
11. Check that the workpiece is properly supported.
16. Spindle
17. Exhaust vent
18. Inhalation vent
19. Limit mark
20. Holder cap cover
21. Screwdriver
22. Brush holder cap
BGA452
115 mm
M14
10,000
317 mm
1.9 kg
D.C. 18 V
ENB099-1