Stroller Insert; Hood; Bumber Bar; 5-Point Safety Harness - Mutsy Transporter Manual De Instrucciones

the left.
· Locate the bassinet on the adap-
ters you have fitted, using the fitting
points on the underside of the cot;
press the cot onto the adaptors until
it clicks into place. (J)
! Position the bassinet so that the foot
end faces the handle grip.
removing the bassinet
· Press in the two buttons (next to the
hood hinge points) so that the bas-
sinet comes free of its attachments.
The bassinet can now be removed
from the frame. (K)
· The hood can be raised to allow the
bassinet to be carried by hand.
· A carrying handle is built into the

hood.

removing the adapters.
· Remove the adapters from the central
attachment points by pressing in the
lip (below the attachment point) and
then sliding the adapter upwards at an
angle. (L)
! Replace the central attachment point
cover caps. (M)
hood
· The bassinet hood is not removable
and has a built-in carrying handle.
· The hood can be moved down when
the buttons to the outside of the hinge
points are pressed in.

stroller insert

Fitting
· The stroller insert is fitted by s liding
the 4 hooks into the plastic b ridging
pieces fitted to the frame, and attach-
ing the 4 poppers and two clips on
the seat to the frame. Two of these
poppers and the two clips must be at-
tached under the foot support. (N)
adjustable back support
· The back support can be lowered or
raised using the strap to the rear of
the support. The back s upport can be
placed steplessly in the desired posi-
tion (O) by pressing in the two lips on
the plastic section and then adjusting
the length of the strap. (P)
adjusting the foot rest
· To adjust the foot rest, move both plas-
tic handles (L+R) under the foot rest
towards you while simultaneously mo-
ving the foot rest into the desired po-
sition. (Q)
hood
Fitting and removal
· Slide the plastic hood fixings over the
frame sections provided for this pur-
pose. (R)
· Slide the fixings back on the frame to
remove the hood.
Opening and closing
· To open the hood, press the front of
the hood forwards and the hood ten-
sioners down. (S)
· To close the hood, press the hood ten-
sioners up and the front of the hood
backwards. (T)

Bumber bar

· Attach the front guard to the frame by
sliding it over the fixing points on the
hood. (U)
· If the hood is not fitted you can attach
the front guard directly to the frame.
· Slide it off the frame to remove it.
· The child can easily be removed from
the seat by freeing the bumber bar on
one side and then moving it outwards.

5-point safety harness

! Always use the safety harness when
English
13