Dometic Waeco CombiPower 2012 Instrucciones De Montaje página 75

_CombiPower_IA_DE-IT.book Seite 75 Freitag, 21. Oktober 2011 8:10 20
CombiPower
6.6 Inverter function
In inverter mode, the device supplies a regulated 230 V voltage.
The maximum constant output is 2000 VA. Do not connect any devices with
a higher power rating. If you connect several devices, make sure their total
power rating does not exceed 2000 VA.
NOTE
I
Note when connecting devices with an electrical drive (such as
power drills, refrigerators and switched-mode power supplies), that
they often need more power than is stated on the type plate.
An adjustable energy saving mode protects the battery. It regularly checks
whether battery power needs to be used. If not, the function is deactivated
and no idle current is used.
6.7 Connections
A battery is connected to the positive and negative terminals. A 230 V power
source can be connected to the "AC INPUT" input (fig. 1 6, page 3). The
power supply via "AC INPUT" takes precedence over the battery power
supply, so that the battery is not discharged unnecessarily.
Voltage is present at the outputs under the following conditions:
 "INV. AC OUTPUT" (fig. 1 4, page 3)
– A battery is connected
– A 230 V power source is connected
– A battery and a 230 V power source are connected
(The battery is charged when the consumer devices do not require all
the power)
 "AC OUTPUT" (fig. 1 5, page 3)
– A 230 V power source is connected
EN
Technical description
75