Troubleshooting - Rain Bird WTD 2900 Manual Del Propietário

WTD 2900
English
TROUBLE SHOOTING
Symptom
Timer switch off ( no sym- - Low batteries
bols on the screen )
There is a water leakage at - The timer is not correctly align with the
the faucet nut (G). faucet outlet.
- The filter with built-in seal is missing
- The nut is not tighten enough
- The faucet outlet has not a flat surface to
provide good sealing
There is a water leakage at - Missing seal
hose adapter (H). - Adapter not tighten enough
- Hose connector is not correctly installed.
Timer does not irrigate - Faucet is closed or no water supply.
- Batteries are flat.
- Batteries are not correctly oriented into
battery holder.
Timer does not close when - Battery holder is not correctly locked.
icon is placed in "OFF - Batteries are flat.
position" - Batteries are not correctly oriented into
battery holder.
- Batteries or battery holder are wet or
dirty
Automatic watering does See in the right column " Solution"
not start or not at expected - Icon is on "OFF" position
hour. - Current time is not correctly set-up
- Current time has been correctly set up
but not at an exact hour (ex: when it was
8h40)
- There is no irrigation programmed that
day because irrigation frequency is set-
up on one every 2 days or more.
Automatic irrigation does See in the right column " Solution"
not stop.
www.rainbird.eu
Cause Solution
- Replace the batteries by brand new
batteries. Make sure to set again current
time.
- Unscrew the timer and install it
correctly following the instructions
provided in this manual.
- Make sure the filter is in place and
correctly oriented.
- Screw the nut.
- Clean the faucet outlet or change the faucet
- Make sure the seal is in place.
- Tighten the adapter.
- Resinstall correctly Hose connector on
adapter.
- Open Faucet. Check water is available.
- Replace batteries by brand new batteries
- Place batteries according to the white
label instructions on the battery holder.
- Make sure battery holder is correctly
locked.
- Replace batteries by brand new batteries
- Place batteries according to the white
label instructions on the battery holder.
- Clean and dry batteries and battery
holder.
First try to make a manual start and fol-
low solutions above in case of failure
- Icon on a watering time position.
- Check current time as explained in
instruction manual. Set it up if needed.
- Change the frequency or make sure
you have correctly programmed the1st
watering day.
Try to make a manual stop and follow
solutions above in case of failure.
9