Control Panel; Description Of Leds And Buttons - Maxx Ice MIM50 Manual De Instrucciones, Instalación Y Mantenimiento

11/07/2017 PK
Allow 30 minutes for proper cleaning. After cleaning, press the ON/OFF switch again. Use a drain hose on the
4.
front of the water trough to drain off the waste water to a convenient container. Don't drain off the waste
water to the inside of the cabinet.
Repeat steps 3 and 4 (without Ice Machine Cleaning Solution) three times to rinse the ice making
5.
system thoroughly.
Next, prepare a sanitizing solution made of 1 ounce of household bleach and 2 gallons of hot water (95˚ to 115˚F).
6.
Fill a spray bottle with the sanitizing solution and spray all corners and edges, making sure to cover all surfaces
with the solution. Wipe the entire bin inside and outside, covering the entire surface of the walls. Allow the
solution to be in contact for at least 3 minutes, then dry.
Repeat steps 1 to 5 with the sanitizing solution of step 6 (bleach and water). Filling the water through to its
7.
maximum level.
Repeat steps 3 and 4 to rinse the ice making system one more time.
8.
Press the ON/OFF button again. The ice maker will return to the regular ice making mode. Discard the first
9.
batch of ice.
DO NOT use or mix with any other solvent-based cleaner products. Use rubber gloves to protect hands.
Carefully read the material safety instructions on the container of the ice machine cleaner.

CONTROL PANEL

MIM50V / MIM50 / MIM50P
Front Inside Door

Description Of LEDs And Buttons

Bin Full (Red) LED: Bin full indicator light
1.
When this is lit, the ice storage bin is full of ice or there is something blocking the bin-full probe. The unit will
stop working. When ice cubes are removed from the ice storage bin, freeing the bin-full probe, the red LED
will remain flashing for 3 minutes, then the unit will restart and return to the ice making mode.
Ice Making (Green) LED: Ice making indicator light
2.
When this is lit, the unit is working in the ice making mode controlled by a temperature sensor.
Ice Harvest (Yellow) LED: Ice harvest indicator light
3.
When this is lit, the unit is working in the ice harvest mode controlled by the ice-full probe.
Mode button: Mainly for service. When this is pressed, the ice making mode changes to the ice harvest mode
4.
or vice versa. The mode can be judged from the status of the green and yellow LEDs.
Adjust button: To be used by an authorized service technician.
5.
The ice machine cleaner contains acids.
Discard the first batch of ice produced after cleaning.
/ MIM50P-O
WARNING
Front Inside Door
MIM50-O
Back
(Behind access panel)
17