Agri-Fab 19A-116-OEM Manual De Operador página 10

USE EXTREME CAUTION when removing
spreader from tractor! A falling spreader can
cause injury!
REMOVING THE SPREADER
13. Disconnect the spreader from the vehicle battery by
unplugging the short wire harness from the long wire
harness. The short wire harness may be left permanently
attached to the battery.
14. Remove the hairpin cotters, washers and clevis pins
securing the mounting brackets to the frame of the
tractor.
15. Slide the mounting brackets off of the bolts in the tractor
frame.
STORAGE
1. Rinse inside of hopper and exterior of spreader and dry
off before storing.
2. Store in a clean, dry area.
Hopper closure plate does not open to
the correct position.
Spreader motor doesn't run.
Spreader motor runs backwards.
Motor runs when switch is shut off.
TROUBLE SHOOTING POINTS
1. Material packed around plate
1. Loose connection in spreader wiring
2. In line fuse is blown.
3. Loose battery connection
4. Battery is run down.
5. Broken spreader wiring
6. Spreader switch is broken.
7. Spreader motor is broken.
1. Wired backwards to battery.
1. Wired backwards to battery.
2. Spreader on-off switch is broken.
MAINTENANCE
CHECK FOR LOOSE FASTENERS
1. Before each use make a thorough visual check of the
spreader for any bolts and nuts which may have loosened.
Retighten any loose bolts and nuts.
CHECK FOR WORN OF DAMAGED PARTS
2. Check for worn or damaged parts before each use.
Repair or replace parts if necessary.
CLEANING
3. Rinse inside of hopper and exterior of spreader and dry
off before storing.
1. Clean out around closure plate
1. Check and reconnect.
2. Replace fuse.
3. Tighten battery terminals.
4. Recharge the battery.
5. Replace damaged wiring.
6. Replace the switch
7. Repair or replace motor.
1. Switch wiring at battery terminals.
1. Switch wiring at battery terminals.
2. Replace the switch.
10