Intex ECO 7220 Manual Del Propietário página 18

(260IO) MODEL ECO 8220/8230 & 7220/7230 SALTWATER SYSTEM ENGLISH 7.5" X 10.3" PANTONE 295U 08/15/2014
OPERATION INSTRUCTIONS (continued)
6. Boost cycle
• First time installation, press and hold "BOOST"
button for 5 seconds until the indicator lights up and the
LED display "80". This indicates that the saltwater
system has started E.C.O. and more chlorine sanitizer
production. You can press and hold the "BOOST" button for
another 5 seconds until the indicator is off, which will cancel
the Boost cycle.
•
The boost operating hours is 8 times the amount of time programmed into the system, i.e. if your
saltwater system operating time is 2 hours, the boost procedure will run 8 x 2 = 16 hours.
After boost procedure has been completed, the system will automatically switch to the
normal working mode.
• Once the boost is operating, check whether the filter pump operating hours have been set
properly. For example, the boost operating time is 8 hours, the filter pump should be set to
run for 8 hours at least. Increase the filter pump operating time if necessary.
Note: If an Intex filter pump is attached to the system, set the pump switch to on "I" position.
• After a heavy rain or if the pool is dirty, press the "BOOST" button to shock the pool again.
7. Stand-by/power saving mode:
•
When the cycle ends, the green "SLEEP" indicator on the
control panel lights up and the LED display flashes "93".
The system is now in Stand-By mode. After a while, it
shuts down and sets itself in a Power Saving mode. The
system will automatically turn itself back on in 24 hours,
starting its daily cycle of chlorine production.
• The "SLEEP" indicator stays on, while the system is in the
Power Saving mode. The LED display however, goes blank
after 5 minutes. Press any button (
LED code.
SAVE THESE INSTRUCTIONS
or ) to view the last
260
English
A
Page 18