Assembly; Operating Instructions - Skil HD529501 Manual Del Propietário

ASSEMBLY

Removable Belt Clip (Fig . 2)
Your tool is equipped with a removable belt clip
that can be positioned on the left side of the
tool for convenient transport.
Install the belt clip onto the tool:
a. Remove the battery pack from the tool.
b. Align the rib of the belt clip with the threaded
hole on the base of the tool.
c. Insert the screw and securely tighten the
screw with a screwdriver.
Remove the belt clip from the tool:
d. Remove the battery pack from the tool.
e. Use a screwdriver to loosen the screw that
attaches the belt clip to the hammer drill.
f. Remove the screw and the belt clip.
NOTICE: Install or remove the belt clip as you need.

OPERATING INSTRUCTIONS

WARNING
fluid or allow a fluid to flow inside them. Corrosive or conductive fluids, such as seawater,
certain industrial chemicals, and bleach or bleach-containing products, etc, can cause a short
circuit.
WARNING
could result in serious personal injury.
WARNING
is misuse and could result in a hazardous condition leading to possible serious injury.
WARNING
assembling parts .
This cordless hammer drill must be used only with the battery packs and chargers
listed below:
2Ah 2Ah
SKIL SKIL
BY519701 BY519702
NOTICE: Please refer to the battery and charger manuals for detailed operating information.
To reduce the risk of fire, personal injury, and product damage due to
a short circuit, never immerse your tool, battery pack or charger in
If any parts are damaged or missing, do not operate this product until
the parts are replaced . Use of this product with damaged or missing parts
Do not attempt to modify this tool or create accessories not
recommended for use with this tool . Any such alteration or modification
To prevent accidental starting that could cause serious personal
injury, always remove the battery pack from the tool when
Battery Pack
2.5Ah
SKIL
BY519703
Fig. 2
4Ah 5Ah
SKIL SKIL
BY519601 BY519603
Charger
SKIL SKIL
SC535801 QC536001
11