Shield Installation - Solo 128L Manual De Instrucciones

Preparing the equipment for use

5.2 Shield installation

When assembling the guard, the damping inserts
from the accessories pack must be fitted into the
guard and mounting bracket in accordance with
Figures 3a - 3e below.
Fig. 3a
Fig. 3b
Fig. 3d
ENGLISH 10
Fig. 4a
 Position the brushcutter with the output shaft
facing downward.
 Raise the shaft tube and slide the guard (16)
Fig. 3c
along the underside of the shaft tube into the
correct position (it should reach a stop at the
angular gearbox).
 Lay down the shaft tube with the guard.
 First insert a 5 x 20 mm bolt through hole a to
tighten the retainer (17) on the guard. Then
insert the second 5 x 20 mm bolt through hole
b, tightening finger tight only at this stage.
(Note: The retainer has a raised part on the inside
near hole a. This allows the first bolt (which is
inserted through hole a) to be tightened straight
onto the block without any risk of the connection
not being straight.)
Fig. 4b
Fig. 3e
 Reposition the brushcutter with the output shaft
facing upward.
 Insert the two long 5 x 35 mm bolts through the
hole on the retaining bracket of the angular
gearbox and tighten the guard and the retainer.
The holes must line up exactly, so it may be
necessary to adjust the position of the guard
first.
 To finish off, fully tighten the bolt in hole b.