Pressure Control Knob Settings; Connection To The Mains Network - Titan IMPACT 1040 Instrucciones De Uso

starting operation
Solid yellow
When the pressure indicator is solid yellow, the sprayer is
operating between 1.4 MPa (14 bar) and 12 MPa (120 bar). A
solid yellow pressure indicator means:
•
The sprayer is at the proper pressure setting for spraying
stain, lacquer, varnish, and multi-colors
Solid green
When the pressure indicator is solid green, the sprayer is
operating between 12 MPa (120 bar) and 23 MPa (230 bar). A
solid green pressure indicator means:
•
The sprayer is at the proper pressure setting for spraying
oil-based and latex house paints
•
The sprayer is operating at peak performance at a high
pressure setting
•
If the pressure indicator goes to solid yellow when the
pressure is set so that it starts at solid green, it indicates
one of the following:
a. Tip Wear Indicator — when spraying with latex or at high
pressure the solid yellow appears. This means the tip is
worn and needs to be replaced.
b. Tip Too large — when a tip that is too large for the sprayer
is put in the gun, the pressure indicator will turn from solid
green to solid yellow.
c. fluid Section Wear — if a solid yellow pressure indicator
appears when using a new tip and the pressure is set at
maximum, service may be required (worn packings, worn
piston, stuck valve, etc...).
14
4.3

preSSure coNTrol kNoB SeTTINgS

1. Minimum pressure setting
2. Black zone – no pressure generation
3. Blue zone – pulsating pressure for cleaning
1
2
3
4.4

coNNecTIoN To The mAINS NeTWork

The unit must be connected to an appropriately-
grounded safety outlet.
Before connecting the unit to the mains supply, ensure that the
line voltage matches that speciied on the unit's rating plate.
The connection must be equipped with a residual current
protective device with INF ≤ 30 mA.
Titan's accessories program also includes a
i
mobile operator protection device for the
electronic supply, which can also be used with
other electronic equipment.
Impact 1040