Using For The First Time - Kuhn Rikon Durotherm Instrucciones De Uso

Safety element
The safety element is located under one of the two grips. In the case of a leak, mostly
caused by a fall, a heavy impact or a leak in the safety element, water could penetrate
into the hollow space. When the cookware is heated up, a steam over-pressure could
thereby develop. This will activate the safety element.
If the following symptoms are detected, the cookware should no longer be used and
you should contact the nearest KUHN RIKON Service Station:
– Visible escape of steam below a grip
– Audible escape of steam below a grip
– A grip becomes hot, noticeably hotter than the other
– The safety element is missing or has fallen out
– Audible water noises in the hollow space
3

USING FOR THE FIRST TIME

– Before using your DUROTHERM the fi rst time, wash it out thoroughly with
hot water and detergent, including the lid.
– For optimally energy-saving cooking, the hotplate should be the same diameter
as the base of your DUROTHERM as marked on the exterior (see the Tips for
saving power point, page 39,
– On electric induction stoves with standard hotplates of 1,500 W or more, pans
marked " 14.5" must be placed exactly in the centre and not used at maximum
temperature. Otherwise the exterior of your DUROTHERM will be discoloured by
the heat.
– On gas stoves, the burner fl ame spread must be adjusted to suit the pan diameter.
If the fl ames impinge on the side of your DUROTHERM, it will be discoloured
by the heat (due to oxidation). We recommend using a gas fl ame diffusor (see
DUROTHERM accessories on pages 52 – 53).
– Before cooking, always be sure to remove the heat-retaining base. Recommen-
dation: Keep the heat-retaining base separately from your DUROTHERM pan.
– Chlorides (e.g. salt) can corrode stainless steel! So when you add salt, always
dissolve it completely in hot water by stirring. And never keep salty food for a long
time in the pan. Otherwise your beautiful stainless steel DUROTHERM will suffer!
– Never leave your DUROTHERM empty on the hotplate for long, otherwise it will be
damaged as well as the hotplate!
36
= hotplate diameter).