Leggett & Platt Premium Serie Manual De Usuario página 14

REMOTE CONTROL PROGRAMMING (1 or 2 remote controls - 2 bases)
Program One Remote to Operate Two Bases (Tandem Syncing)
- perform the following numbered procedure. Note: Make
sure both remotes are in "press & hold" mode and both bases
are fl at before beginning procedure.
OPERATE 1 OR MORE BASES, BOTH REMOTES MUST BE IN THE
SAME "PRESS & HOLD" OR "PRESS & RELEASE" MODE FOR FLAT OR
PROGRAMMABLE BUTTONS TO FUNCTION.
STEP 1
Plug both adjustable bases into electrical power source.
Operate both remote controls to verify each remote
functions properly with its respective base. NOTE: see
1-to-1 programming procedure if bases do not operate.
Using remote controls, adjust both bases to fl at position.
STEP 2
UNPLUG both bases from electrical power outlet.
STEP 3
Choose base 1 remote. Retain base 2 remote control as a
spare or use if 2 remotes are desired to operate both bases.
STEP 4
Position both bases on their sides, in close proximity
to each other. CAUTION: AT LEAST TWO PEOPLE
ARE RECOMMENDED FOR HANDLING AND MOVING
ADJUSTABLE BASE.
STEP 5
Locate dual sync cable (FIGURE 12).
FIGURE 12
DUAL SYNC
CABLE
STEP 6
On base 1, unplug the existing cable from the control box
(FIGURE 13). Insert one male plug of dual sync cable into
the control box (FIGURE 14). Insert removed cable into
the female plug of the dual sync cable (FIGURE 15).
FIGURE 13
EXISTING
CABLE
14
Prodigy™ 2.0 Adjustable Base Owners Manual 99301584-c
IF USING 2 REMOTES TO
CONTROL
BOX
OR
REMOTE 1 REMOTE 2
FIGURE 14
MALE
PLUG
FEMALE
PLUG
FIGURE 15
FEMALE
CONTROL PLUG
BOX
STEP 7
Repeat Step 6 with base 2, using the remaining male and
female plugs of the dual sync cable.
STEP 8
Turn both bases over so they are resting on their legs.
CAUTION: MAKE SURE CABLE IS CLEAR OF BASE AND FREE
OF ANY PINCH POINTS.
STEP 9
Plug both bases into electrical power source.
STEP 10
Operate both bases with the remote control. NOTE: If
bases do not operate in unison with the remote, verify
dual sync cable connections are fully seated in both MFP
ports. Unplug both bases, wait 10 seconds, then plug
them back in.
BASE 1
BASE 2
DUAL
SYNC
CABLE
CONTROL
BOX
CABLE
REMOVED
FROM
CONTROL
BOX