Leggett & Platt Premium Serie Manual De Usuario página 8

STEP 5
Remove the plastic packaging from the base frame. Carefully rotate the
adjustable base over to position the base so it is resting on its legs (FIGURE 2).
FIGURE 2
STEP 6
Plug electrical power cord into a working, grounded electrical outlet.
Note: An electrical surge protection device is recommended (not included).
STEP 7
Install batteries in remote control (3-AAA, included) (FIGURE 3). Note:
Make sure batteries are properly oriented. Briefl y activate all functions of the
base with the remote control to verify all features are in working order. If
base does not operate, refer to the Troubleshooting section of this manual.
FIGURE 3
BATTERY
COMPARTMENT
DOOR
PRESS IN ON TAB AND LIFT
OUT TO REMOVE BATTERY
COMPARTMENT DOOR.
INSERT TABS IN TAB SLOTS
AND SNAP IN TO REPLACE.
STEP 8
Return base to the level position.
8
Prodigy™ 2.0 Adjustable Base Owners Manual 99301584-c
INSTALLATION
POSITIVE (+)
END
TAB
4-PORT CHARGING HUB
(located on each side of
base, for charging low-
voltage devices only)
POSITIVE (+)
END