Mute Setting; Using The Vox Function To Adjust The Transmission Sensitivity; Cleaning; Technical Data - TIGEX Easy Protect Instrucciones De Uso

corresponding volume indicators 2 will be illuminated. The
louder your chosen setting, the louder will be any beeps
and the more volume indicators 2 will light up.
Note: When the VOX function is set to low sensitivity (see
"9.2 Using the VOX function to adjust the transmission
sensitivity" on page 42), then quiet sounds will not be
transmitted regardless of the volume setting. This means
that turning up the volume will not enable you to hear
anything more. If you want to hear more of the sounds from
the nursery you will need to increase the transmission
sensitivity by selecting a higher VOX level.

Mute Setting

The parent unit 1 can be "MUTED". Sounds from the
nursery will be transmitted but no longer heard. The noise
level indicators 2 will continue to indicate the noise level in
the nursery. The more LEDs are lit the louder are the noises
in the nursery.
When reducing the volume to mute at the end you will hear
a double beep.
9.2 Using the VOX function to adjust the
transmission sensitivity
Babies make a lot of different noises. These can range from
loud breathing through babbling to calling or loud crying.
The VOX function can be set up in such a way that only
Warning! To avoid the risk of electric shocks,
injuries and damage:
– Always disconnect the mains adapter from
the power socket before cleaning the device.
– Never immerse the individual parts in water.
Wireless connection
Transmission frequency
Number of channels
Outdoor range
Indoor range
Operating temperature
Operating temperature
Batteries

10. Cleaning

11. Technical data

2.4 GHz FHSS
2400-2483.5 MHz, < 20 dBm
36 / automatic channel selection
app. 300 m (free field without interferences)
app. 50 m
Successful transmission depends on the environment. Walls or trees can seriously
interfere with reception.
Baby unit
0 °C to 40 °C ambient temperature
Parent unit
0 °C to 40 °C ambient temperature
3x AAA 1,5 V (not included)
42
loud sounds such as crying or calling are transmitted while
quieter sounds are not registered.
The VOX function sets up the transmission sensitivity of the
microphone. The higher the VOX level the more sensitive
the device is to noises.
Activate the VOX function by briefly pressing the VOX
button 3.
The VOX level indicators 2 start flashing and are indicating
the current set level.
By pressing the VOX adjustment buttons 4 the sensitivity
can be increased (+) or decreased (-).
VOX level 1 = extremely low sensitivity, reacts only if baby
screams very loudly;
VOX level 2 = low sensitivity, reacts if baby screams loudly;
VOX level 3 = normal sensitivity, reacts if baby cries
normally;
VOX level 4 = high sensitivity, reacts even to slight sounds;
VOX level 5 = Eco-Mode is switched off. The unit is set to
transmit continuously.
Note: After activating the VOX function, you have about
two seconds to alter the transmission sensitivity. The
device will then automatically switch back to transmitting
sounds. You can see this has happened because the level
indicators 2 will no longer be flashing, and the volume and
VOX adjustment buttons 4 now only modify the volume.
Caution! Under no circumstances use abrasive, corrosive
or scratching cleaning agents, as these could damage the
device.
1. If necessary, wipe the individual parts with a damp
cloth.
2. Only use the baby monitor again when all the parts
have fully dried out.