Unit Description; Initial Use - Beurer LW 110 Serie Instrucciones De Uso

4. Unit description

1. Fan button
2. On/Off button
3. Air inlet
4. LCD display
5. Air outlet
6. Fill level sensor
7. Handle recess
8. Lock
9. Fan unit
10. Upper cover
11. Holder
12. Humidification discs
13. Tub

5. Initial use

Remove the transport lock
• Open the cardboard packaging.
• Keep the plastic film closed and remove the device upwards by lifting it out using the handle recesses on
the upper cover.
• Now remove the plastic covering.
• Check the device, mains plug and cable for damage.
• Lift off the upper cover with the fan unit, lift out the humidification discs at the holder and remove the
transport lock from the tank and the fan unit. Check whether all transport locks have been removed.
• Reinsert the humidification discs. The holder automatically falls to the side and the humidification discs
are secured.
Fill with water
• To fill the tub, lift out the upper cover with fan unit by the side handle recesses and place to one side.
• During filling, leave the humidification discs in the tub. Fill the tub with fresh, cold tap water at most up to
the lower edge of the "MAX" marking on the inside of the tub. The most straightforward way to do so is
to use a large container free of limescale and impurities (water can, jug). Use only fresh, cold tap water.
We recommend a filling volume of 3,6 l, to achieve optimal humidification output.
1
2
3
4
5
6
7
8
9
10
11
12
13
13