H.backrest Angle Adjustment; Seat Height Adjustment; Tm40 Single Or Dual Switch Actuator Controller - Quickie Freestyle M11 C. G. Tilt Manual De Instrucciones

8
H. BACKREST ANGLE ADJUSTMENT
A backrest angle adjustment is standard.
Adjustment on Seat Frame
1. Remove the front securing bolt (A) on the side of the backrest hinge plate.
2. Loosen the lower rear bolt (B).
3. Set at desired angle. There are four holes (in 4º increments) to choose from.
4. Reinstall the front bolt and tighten both bolts securely.
I. SEAT HEIGHT ADJUSTMENT
The seat height can be adjusted from 17.5" - 21.5" (M11) and 19" - 23" (F11) at
1" increments.
1. Remove the seat.
2. Reposition all four of the seat mounts (C) to desired position by removing pins (D),
adjusting mounts and replacing pins.
3. Ensure that the top of all seat mounts sit at the same height (except as noted
below).
4. Replace seat.
NOTE– 1" of seat angle can be set by lowering the rear post two hole positions.
In all configurations of seat height and fixed tilt angles, ensure that both the
front and rear latches (2) are all properly engaged.
J. TM40 SINGLE OR DUAL SWITCH ACTUATOR CONTROLLER
The TM40 actuator controller can be used to activate the tilt mechanism with either single
or dual switch controls.
1. Plug limit switch harness assembly (1) into TM40 limit switch jack (2).
2. Plug single switch (3) into TM40 single switch jack (4) OR plug dual switch (5) into
TM40 dual switch jack (6).
3. Plug TM40 into the QTRONIX Power Module (7).
4. Use mating plugs (8) to connect the TM40 to the tilt actuator.
TILT ACTUATOR
UPRIGHT STOP
VSI CONTROLLER
930584 Rev. A
E n g l i s h
(Figure 8)
(Figures 9 & 10)
DRIVE INHIBIT TILT STOP
SWITCH
SWITCH
SWITCH
8
OR
9-PIN
CONNECT
QTRONIX POWER MODULE
V . S e t - u p , A d j u s t m e n t & U s e
(Figure 11)
1
DUAL
SWITCH
5
2
6
4
3
SINGLE
SWITCH
TO ONBOARD
CHARGER
7
B
A
C
D
Front Mounts
Rear Mounts
11
8
9
10
C
D